Cooper Menvier Menvier 9651, Руководство пользователя

Страница: 18 / 28

3. After an Alarm
Page 18 496930
• If the
s
lamp glows after an alarm and your system is connected to an
communication device then your system may use Remote Reset . Your
alarm company will give you instructions over the phone and a special
code so that you can reset the system from the keypad.
Customer Reset
1. Key in your access code or present a tag and press
Y
.
The display clears.
2. You can now use your system as normal.
Remote Reset
Before starting this process, make sure you have a pen and paper to hand.
You will need to write down some information shown on the keypad. If you
have not carried out a remote reset before, read the instructions through
before starting.
1. Key in your access code or present a tag
The display shows:
2. Press
Y
.
The display shows a four
digit Reset Code.
3. Write down the four digit Reset Code.
Note: that the system will display the Reset Code for 30 seconds and
then return to showing the first detector to alarm. If you miss the
Reset Code repeat steps 1 to 3.
4. Contact your alarm company.
The company will ask a few questions to make sure you are who
you say you are. They will then ask for the circumstances of the
alarm, and for the Reset Code. If they do not need to send an
Engineer to check the system they will give you an "Anti Code".
5. Key in the Anti Code on the keypad.
The display clears and the
Service lamp goes out.
6. You can now use your system as normal.
Select?
Reset code = 1234
04/02/00 17:33