CONSTRUCTA 9000472481, Инструкция по эксплуатации

Страница: 72 / 76

72
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
m
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and
push downwards (figure D).
Faults and repairs
In the event of a fault, check the tips in the following table
before calling the after-sales service.
m
Risk of electric shock!
Work on the appliance electronics may only be performed by
an expert. Disconnect the appliance from the power supply.
Switch off the circuit breaker or take out the fuse in the
household fuse box.
A B
a
a
C D
Problem Possible cause Remedial action
Electrical operation is malfunctioning (e.g.
indicator lamps do not light up)
Faulty fuse Check fuses in the fuse box and replace if
necessary
Liquid or thin dough runs to one side Appliance not installed level Check the appliance installation (see the
Installation instructions)
Appliance no longer works,
‹
:
‹‹
flashes in
the clock display
Electricity supply was cut Reset the clock (see section: Electronic
clock)
‹
:
‹‹
flashes on the clock display, “rrr”
appears on the temperature display
Power supply was interrupted while the
appliance was in operation
Press the clock function button.
“E011” appears in the temperature display Permanent assignment of a button Cancel the permanent assignment of the
button and press the clock function button
The temperature display shows, "EXXX",
e.g. E300
Internal fault in the appliance electronics Press the clock function button. If the
message does not go out, pull out the
mains plug and plug it back in again after
approx. 10 seconds
Appliance operation is not possible,
D
and -
†
- appear in the temperature display
The appliance has been locked Deactivate lock (see section: Childproof
lock)
Appliance operation is not possible,
D
and -
†˜
appear in the temperature display
The appliance controls are locked
permanently
Deactivate permanent lock (see
section: Childproof lock)
The appliance does not heat up, the two
dots flash on the clock display
‚‡‹©
appears in the temperature display, for
example
A button combination was actuated Switch off the appliance, press and hold
the info button for 3 seconds, then press
and hold the clock function button for 4
seconds before pressing and holding the
info button again for a further 3 seconds
Electronically controlled functions are
malfunctioning
Energy surges (e.g. lightning strike) Reset the function concerned
When an operating mode is switched on,
•
or
œ
appears in the temperature display
The appliance has not cooled down fully Wait until the appliance has cooled down,
then switch on the operating mode again
The appliance has switched off
automatically,
‹‹‹
flashes in the
temperature display
The appliance has switched off to protect
itself from overheating
Press any button or turn the selector, the
appliance switches back on
Smoke is generated during roasting or
grilling
Fat is burning on the grill element Continue grilling or roasting until the fat on
the grill element is burnt away
Wire rack or universal pan inserted
incorrectly
Place the wire rack in the universal pan
and insert them together at a lower shelf
height