EN
EN
49
48
VP8336 | VP8337 | VP8338 | VP8339
VP8336 | VP8337 | VP8338 | VP8339
29
VP9181
EN
CLEANING AND REPLACING THE AIR OUTLET FILTER
1. Open the air outlet grid in the appliance‘s rear section (Fig. 5).
2. Remove the air outlet filter. This type of vacuum cleaner is equipped with a
H.E.P.A. filter in the outlet, which is capable of catching even very fine dust
particles. You can clean this filter by tapping it, then brushing it with a soft
brush. After this operation is complete, you may clean a very dirty filter by
washing and brushing with a soft brush in lukewarm water with no cleaning
agents added. It is important to let the wet parts dry thoroughly. A wet filter
will be damaged by vacuuming! Do not use a hair dryer to dry it!
Note:
Wet cleaning may cause more wear and tear of the filter and,
consequently, may shorten its service life.
3. Insert the cleaned or new air outlet filter into the appliance and close the air
outlet grid.
TROUBLESHOOTING
Problem
Cause
Solution
Motor does not run.
Plug inserted into the mains outlet
incorrectly or insufficiently.
Check the plug connection.
The mains outlet is not live.
Check for voltage, e.g. by connecting
another appliance.
Motor has stopped
operating.
Improper or insufficient air flow. Motor
overheating fuse activated.
Disconnect the cable from the socket.
Check and release the air suction
and discharge holes; check the filter’s
cleanliness and/or replace the dust bag.
Let the vacuum cleaner cool down.
Front cover cannot be
closed
Dust bag inserted incorrectly.
Check the dust filter installation.
Reduced suction power
Dust bag full or clogged.
Replace the dust bag.
Obstructed filter.
Clean or replace the filter.
Clogged nozzle, tube, or hose.
Check and clear the air passage on the
suction and discharge sides.
Vacuum cleaner heats
up
Slight heating of the vacuum cleaner is normal and cannot be considered a failure.
OPTIONAL ACCESSORIES
The following appliance accessories can be purchased additionally:
SMS dust bags (5 units + 2 units of motor filters) Order code sms9000
Priced according to the valid price list
Fabric dust bag, 1
Ord. No. ts9180
Price according to the applicable price list
Motor filter
Order code44290910 Price according to the valid price list
H.E.P.A. air outlet filter
Order code 44290911 Priced according to the valid price list
(Fig. 5)
29
VP8110, VP8111, VP8112
EN
(Fig. 5)
CLEANING AND REPLACING THE AIR OUTLET FILTER
1. Open the air outlet grid in the appliance‘s rear section (Fig. 5).
2. Remove the air outlet filter. You can clean this filter by tapping it, then brushing it
with a soft brush. After this operation is complete, you may clean a very dirty filter by
washing and brushing with a soft brush in lukewarm water with no cleaning agents
added. It is important to let the wet parts dry thoroughly. A wet filter will be dam-
aged by vacuuming! Do not use a hair dryer to dry it!
Note: Wet cleaning may cause more wear and tear of the filter and, consequently,
may shorten its service life.
3. Insert the cleaned or new air outlet filter into the appliance and close the air outlet
grid.
OPTIONAL ACCESSORIES
The following appliance accessories can be purchased additionally:
SMS dust bags (5 units + 2 units of motor filters)
Order code sms9000 Priced according to the valid price list
Fabric dust bag, 1
Order code 44291711 Price according to the applicable price list
Motor filer
Order code 44291704 Price according to the valid price list
28
VP9181
EN
CHECKING THE DUST COLLECTION BAG FILL
When the dust collection bag fill indicator turns red during operation, replace the full dust collection bag immediately.
If the dust collection bag fill indicator is still red after the bag has been replaced, this may be due to several causes:
- some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are obstructed;
- the motor filter is dirty;
- the air outlet filter is dirty.
Check for each of the possible causes above and eliminate the problem before you start vacuuming. If the cause of the
problem cannot be identified, hand over the product to the nearest service centre. Never use the vacuum cleaner if the
bag level indicator is completely red during operation. The motor could be damaged irreparably
CLEANING AND MAINTENANCE
You may clean the accessories and the appliance with a wet cloth. Never immerse
the appliance in water! Do not use any aggressive substances for cleaning, such as
solvents or abrasives!
REPLACING THE DUST COLLECTION BAG
1. Unplug the product from the mains. Disconnect the hose from the suction inlet
and open the appliance cover.
2. Push the flap on the dust retention bag holder; remove the used dust retention
bag (Fig. 3). Dispose of a paper or SMS dust collection bag. Be careful not to tear
the bag when handling.
If the bag is made of fabric, empty it and close it
carefully - it can be used repeatedly.
3. Insert a new or empty dust retention bag by fitting the plate in the bag holder. The
bag opening must be aligned with the hose hole in the appliance cover.
4. Never use the vacuum cleaner without the dust bag installed! If you forget to
insert the dust retention bag or you insert it incorrectly, the appliance‘s motor
may become damaged.
5. Close the cover. Press until you hear a click.
REPLACING FILTERS
• The filters should be cleaned or replaced when they are visibly dirty, or if the
appliance‘s suction power is reduced. Always check the filters after using the
appliance.
• In order to avoid damage to the appliance, do not use it with incorrectly installed
filters.
• Before replacing the filters, disconnect the appliance from the electrical socket.
• You can buy suitable types of filters from your dealer, or you can order them from
the manufacturer.
CLEANING AND REPLACEMENT OF THE MOTOR FILTER
1. Disconnect the flexible hose and open the appliance cover.
2. Pull the dust collection bag out of its holder so that you can access the motor filter
more easily.
3. Remove the motor filter (Fig. 4). You can clean the filter by tapping it. If the filter is
heavily soiled, you may wash it in lukewarm water and let it dry properly.
4. Insert the cleaned or new motor filter into the appliance and close the cover.
(Fig. 3)
(Fig. 4)
28
VP8110, VP8111, VP8112
EN
(Fig. 3)
(Fig. 4)
37
EN
VP 8336
30
VP9181
EN
ENVIRONMENTAL PROTECTION
- Packaging materials and obsolete appliances should be recycled.
- The transport box may be disposed of as sorted waste.
- Polyethylene bags shall be handed over for recycling.
Recycling the product at the end of its service life
The symbol affixed to the product or its packaging indicates that the product may not be disposed of as
household waste. It must be taken to the collection facility authorized for recycling electric and electronic
waste. By ensuring that this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed information about the treatment, recovery and recycling
of this product, please contact your local city office, your household waste disposal service or the shop
where you purchased the product.
SERVICE
Any larger maintenance or repairs requiring intervention into the internal parts of the product shall only be performed
by an authorized service
30
VP8110, VP8111, VP8112
EN
recycling the product at the end of its service life
The symbol affixed to the product or its packaging indicates that the product may not be
disposed of as household waste. It must be taken to the collection facility authorized for
recycling electric and electronic waste. By ensuring that this product is disposed of correctly,
you will help prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product. For more
detailed information about the treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you
purchased the product.
This product meets all the basic EU regulation requirements that relate to it.
38
Changes to the text, design and technical specifications may occur without prior notice and we reserve the
right to make these changes.
EN
VP 8336
