52
VA0020
42
VA0020
EN
OPERATING INSTRUCTIONS
Steps for vacuum packaging of Concept Fresh zipper bags – VB2023, VB2635
1. Place the food into the bag and close it using a special clip supplied with the Concept Fresh VB2023 and VB2635
Fresh bags (Fig. 1).
2. Press the nozzle of the vacuum sealer to the zipper bag valve and press “START” (Fig. 2).
3. Once the vacuum sealing process is completed, the unit automatically turns off. You can then store the bag and its
contents as required.
Important:
The bags are not designed for vacuum packaging of liquids!
Fig. 1
Fig. 2
DESCRIPTION OF THE DEVICE
1. End piece for vacuum packaging of
zipper bags
2. Overflow tank
3. End piece for vacuum packaging of
canisters (removable for easy cleaning)
4. “START” button to start vacuuming
5. Charging dock
6. Charger
6
1
4
3
2
5
43
VA0010
EN
Vacuum sealing of prepared bags from Concept Fresh rolls - VB2203, VB2806
1. Fill the bag so that the content is approx. 7.5 cm from the open end of the bag. Make sure that neither the outside
nor the inside of this part of the bag is contaminated with the stored food.
2. Insert the open end of the bag into the vacuum chamber (6), between the gaskets (5). The end of the bag must be
free of ripples and wrinkles (Fig. 5).
3. Close the lid and by pressing the lid switch on the unit (Fig. 6). After the air is completely removed out of the bag,
the vacuuming process is automatically terminated and the bag is sealed.
4. Before reuse, wait for about 1 minute until the unit cools down.
Important:
Use only original bags made from
Concept Fresh rolls VB2203 and VB2806.
Remove excess moisture before the vacuuming process!
Never vacuum seal bags filled with a liquid!
Vacuum packaging of food in Concept Fresh canisters VD8100, VD8200 and wine stopper VD8300
1. Fill the canister up to 2.5 cm below the edge.
2. Wipe off any food residues or moisture on the edge of the canister.
3. Insert one end of the tube (supplied as part of each set of canisters/wine stoppers) into the vacuum opening (3) in
the vacuum chamber and the other end into the opening in the lid of the canister/stopper (Fig.7).
4. Move the button on the lid of
VD8100 canisters
to the „SEAL“ position. Turn the unit on by pressing the safety
switch (1) and hold it for about 1 minute until the process is completed (Fig. 8). After the vacuuming process is
completed, the unit automatically turns off. Remove the tube from the lid and store the canister as required.
Important:
The sealing element is hot throughout the entire vacuuming process.
Do not touch it!
5. To open the canister:
VD8100 canister set - turn the button on the cover to the „OPEN“ position
VD8200 canister set - press the blue button and hold until the lid cannot be reopened
VD8300 wine stopper set - pull the stopper out the neck of the bottle
Tip:
To prevent loss of the tube, store the tube in the opening inside the lid of the unit
(Fig. 9).
The unit is equipped with an opening in the bottom for the storage of the power
cord. Do not wrap the cord around the appliance!
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Содержание VA0020
Страница 2: ......
