• The electrical safety of the unit can only be guaranteed if the protective terminal of the unit is connected
to the protective conductor of the mains.
• The manufacturer bears no responsibility for damage caused to people or objects as a result of a missing
or bad protective connection.
• The power cord must be located so that it does not come into contact with hot parts of the unit and so
that it is not deformed or excessively bent.
Follow the installation instructions:
1. Remove all the covering and marketing materials from the unit before the first use.
2. For the required built-in box dimensions see Fig. 7a. 7b. For the sake of efficient air circulation the unit
has to be located according to the dimensions on the pictures and the
design of the cabinet must enable air flow into its bottom part.
3. Put the unit on the edge of the cabinet and run the power cord
through the rear wall of the cabinet so that its plug is accessible after
installation.
4. Push the unit carefully to the selected place in the cabinet. Be careful
not to squeeze the power cord.
5. Attach the unit to the cabinet by screwing 2 screws in the holes in the
side walls of the unit. The holes can be seen after opening the door.
6. Plug the supply cable into the wall outlet.
Removal
To uninstall the unit, it is important to proceed correctly:
1. First, unplug the power cord from the mains (pull out the plug or switch off the
circuit breaker).
2. Remove the attachment screws.
3. Slide out the unit and at the same time pull out the power cord carefully.
REPAIR & MAINTENANCE
Bulb replacement
The bulb of the internal space lighting is special, with high thermal resistance (25 W, 300 °C).
For the replacement proceed as follows:
• Pull out the power cord from the mains outlet or switch off the circuit breaker of the unit’s mains outlet.
• Unscrew the covering glass and replace the bulb with a new one of the same type.
• Screw the covering glass back in place.
WARNING!
The customer may only perform the bulb replacement. Any extensive maintenance or repair that requires
access to the inner parts of the product must be performed by an expert service centre.
ENVIRONMENTAL PROTECTION
• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
A symbol on the product or its packaging indicates that this product should not go into
household waste.
It must be taken to the collection point of an electric and electronic equipment recycling
facility. By making sure this product is disposed of properly, you will help prevent the
negative effects on the environment and human health that would otherwise result from
inappropriate disposal of this product. You can learn more about recycling this product from
your local authorities, a household waste disposal service or in the shop where you bought
this product.
EN
EN
57
56
ETV 7960
ETV 7960
