Then install fixed knife no. 2 (front)
1
Install one support rule together with one knife at a time.
Fit the socket cap screws so that the support rule lightly hold the knife.
The socket cap screws are fitted from the inside of the cutter house door.
2
Tips!
Lock the cutter house door in
open position.
Use a block of wood, size 25 x 50,
length 230 mm.
It could otherwise be difficult to fasten the
socket cap screws to the front fixed knife to
the correct tightening torque. Because the
tightening makes in the same direction as the door is closed.
3
Fasten the knife with the socket cap screws and the support rules and tighten
with an alternated increased torque to 100 Nm.
4
5
Fasten the knife with the socket cap screws and the support rules further
with an alternated increased torque to 200 Nm.
NOTE! Knock/hammer between the alternately increasing tightening torque with the
plastic or rubber mallet, so that both the knives and the support rules firmly goes up
and in to the rear of the knife position.
6
Fasten the knife with the socket cap screws and the support rules furthermore
with an alternated increased torque to 400 Nm.
NOTE! Knock/hammer between the alternately increasing tightening torque with the
plastic or rubber mallet, so that both the knives and the support rules firmly goes up
and in to the rear of the knife position.
Support rule Fixed knife pair no. 2 (front) Support rule
230 mm
NOTE:
Use a plastic or rubber mallet and knock/hammer
both the knives and the support rules hardly in and up
against the rear of the knife position.
7 . 1 K n i f e c h a n g i n g
( c o n t i n u e d )
7 - 1 2
l S e r v i c e
