When installing rotating knives, always install all the rotating knives on the
cutter, so that the cutter will be balanced.
Length, dimension and strength class on screws
All screws which retain the knives are of high strength class.
Only screws supplied by Conair may be used for installing knives.
Conair’s responsibility and guarantee become invalid unless genuine
Conair screws of the right length, dimension and strength class are used.
Tightening torque and torque wrench
It is very important that the knives are torqued to correct tightening
torque.
All screws must be tightened using a torque wrench to the specified
tightening torque which is stated in the machine instruction manual.
If a torque wrench is not used or if screws are not tightened to the specified
tightening torque which is stated in the machine instruction manual, Conair’s
responsibility and guarantee become invalid.
Tips for installation of knives:
Mark each knife, with a felt-tip pen when each task is carried out:
= The knife clearance is correctly set.
= The knife screws are torqued to the correct torque.
= The knife clearance has been re-checked and is correct.
Tips for installation of pre-set knives:
Mark each knife, with a felt-tip pen when each task is carried out:
= The knife clearance is correctly set in the pre-setting fixture.
= The knife screws are torqued to the correct torque.
= The knife clearance has been re-checked and is correct.
4 - 1 2
l S e c u r i t y