Comtech EF Data CDM-800, Инструкция по установке и эксплуатации

Страница: 40 / 130

CDM-800 Gateway Router Revision 1
Rear Panel Connections MN-CDM800
3–4
Connection Instructions: Orient the plug to the receptacle in the proper position. Press firmly
into place. Use the jack screws to secure the plug to the receptacle jack nuts. Do not over ‐
tighten.
3.1.3 Circular Cable Connections
Circular connectors are intended for weatherproof outdoor applications. The connector pairs
feature a sleeve lock configuration, with an array of pins (male side) coupled to mating sockets
(female side).
3 Sleeve Lock features
2 Secondary Alignment features
1 Primary Alignment features
Connection Instructions: Engage all of the alignment and lock features
between the male connector (on the interconnection cable) and
female socket (e.g., the ODM/R ‐ 840 Outdoor Remote Router
CONSOLE/REDUNDANCY port or the POWER port).
To install the male connector into the female connector:
1. Engage the primary and secondary alignment tabs on the male
connector with the mating cutouts on the female socket.
2. Push the male connector into the female socket.
3. Turn the male connector sleeve clockwise until the sleeve lock
cutouts engage fully with the female socket tabs and you hear a
“click” sound
3.1.4 RJ-45, RJ-48 Cable Connections
The plug for an RJ ‐ 45 or RJ ‐ 48 cable features a flexible tab. The RJ ‐ 45 or RJ ‐ 48
jack features a mating slot. This design configuration assures proper
installation and pin orientation.
Connection Instructions: Press down the tab on the cable plug, and then
insert the plug into the RJ ‐ 4 x jack. The connection is complete when the tab
‘clicks’ into position inside the jack.
3
2
1