Comtech EF Data CDM-800, Инструкция по установке и эксплуатации

Страница: 116 / 130

CDM-800 Gateway Router Revision 1
Serial-based Remote Product Management MN-CDM800
6–8
6.3 Remote Commands and Queries
The Serial Command Line interface (CLI) (the Controller), shown previously in Figure 5 ‐ 1 , is used to issue remote commands and queries
to the CDM ‐ 800 (the Target). From the CLI command prompt CDM ‐ 800> type in the command or query packet, using the format
explained previously, for transmission to the CDM ‐ 800.
For example: CDM ‐ 800><0000/LC1=3[cr]
The table that follows provides a ‘quick reference‘ to the Instruction Codes available at present for M&C of the CDM ‐ 800. The ‘ C ’ and ‘ Q ’
columns, when marked with an ‘ X ’, denote whether that Instruction Code is Command Only , Query Only , or Command and Query .
INSTRUCTION
CODE
USED TO... C Q Page
DPW Set default passwords X 5 ‐ 9
IG1 Set or query the IP Address and network prefix for the GE ‐ 1 10/100/1000 Gigabit Ethernet Port X X 5 ‐ 9
IG2 Set or query the IP Address and network prefix for the GE ‐ 2 10/100/1000 Gigabit Ethernet Port X X 5 ‐ 10
IPA Set or query the IP Address and network prefix for the FE (10/100 Fast Ethernet) port X X 5 ‐ 10
LC1 Set or query the link configuration for the GE ‐ 1 10/100/1000 Gigabit Ethernet Port X X 5 ‐ 10
LC2 Set or query the link configuration for the GE ‐ 2 10/100/1000 Gigabit Ethernet Port X X 5 ‐ 10
MAC Query the unique router MAC Address X 5 ‐ 11
MG1 Query the unique GE ‐ 1 port MAC Address X 5 ‐ 11
MG2 Query the unique GE ‐ 2 port MAC Address X 5 ‐ 11
MLC Set or query the link configuration for the FE Port X X 5 ‐ 11
NPS Query the negotiated port speeds for the GE ‐ 1, GE ‐ 2, and FE ports X 5 ‐ 11
SRC Set or query the SNMP Read Community String X X 5 ‐ 11
SWC Set or Query the SNMP Write Community String X X 5 ‐ 11