Comtech EF Data CDM-740, Инструкция по установке и эксплуатации

Страница: 57 / 150

CDM-740 Advanced Satellite Modem Revision 0
Front Panel Operation MN-CDM740
5–5
* Note: Config: Tx Æ Scrambler, Config: Rx Æ Descram , and Config: Rx Æ Pilot selections are active only if the Mode selection is DVB-S2 .
5.3 SELECT: (Main) Menu
Select: Configuration Test Monitor
Store/Ld Utility ODU FAST
(
◄►
)
Use the
◄ ►
arrow keys to select from the choices shown, then press
ENTER
. The following
table identifies the menu branch, its content section in this chapter, and the functional description
of each branch:
Menu Branch Sect Description
Configuration 5.4
Permits user to fully configure the modem.
Test 5.5
Permits user to configure the modem into one of several Test modes, and configures/monitors the
BER Tester.
Monitor 5.6
Permits user to monitor the current status of the modem and view the log of stored events for the
modem.
Store/Ld 5.7
Permits user to store configured parameters into one of 10 memory locations and load (recall)
those configurations at a later time.
Utility 5.8
Permits user to set operational features such as time and date, display brightness, redundancy,
Circuit ID, or Firmware boot image selection.
ODU 5.9
(Outdoor Unit) Permits user to monitor and control a Comtech EF Data RF Transceiver (BUC
[Block Up Converter] or LNB [Low-noise Block Down Converter]) , if connected.
FAST 5.10
(Fully Accessible System Topology) Permits user to configure different options, for extended
data rates, interfaces, etc. Contact Comtech EF Data Customer Support for details.