Statox 502 Control Module
Issue 1/2015
Page 5 of 40
Getting started
The Statox 502 control modules are designed for mounting on DIN rail TS 35. Due to the tilted
mounting/dismounting of the modules the span between the outsides of the rail and the wall below and
above the Statox 502 Module must be at least 80 mm (3.15 “). Furthermore at least 120 mm (4.72 “) must
be remain free between two rail lines.
Mounting
The Control Module can be operated without bus adapter, they will be mounted on the
DIN rail as shown in
Figure 2
. In this case each module must be powered separately with
24 VDC.
1.
Plug the bus adapters together and snap them on the DIN rail as shown in
Figure 1.
2.
Incline the module and move it to the lower part of the DIN Rail. See
Figure 2.
3.
Now push the module forward to the rail against the resistance of the spring lock, until you hear it
snapping in.
Set with 2 bus adapters, obligatory
for each module in bus operation,
Art.# 557002
Connection set for bus adapter
(Bus plug left and right),
optional, Art.# 557003
DIN rail TS 35
Figure 1: Requirements for bus operation, sample installation
Control Module, Art.# 557000
Control Module, Art.# 557000, configured as Common Alarm Module
Power supply
24 VDC
!
