Compaq 5500R - ProLiant - 256 MB RAM, Руководство по техническому обслуживанию и ремонту

Страница: 43 / 165

2-28 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
For use with Pentium II and Pentium III Xeon processor-based servers only
Processor Power Module
Each processor requires one processor power module. If a module become defective, it must be
replaced. To replace a processor power module:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
3. Pull up the ejector levers .
4. Lift the processor power module out of the connector socket .
1
2
1
Figure 2-22. Removing the processor power module
NOTE:
The processor power module must be installed in the slot next to the processor. See Figure 2-19
for processor power module locations.
Reverse steps 1 through 4 to replace the processor power module.