4-18
Compaq StorageWorks SAN Switch 8 Installation and Hardware Guide
Compaq Confidential – Need to Know Required
Writer: Hilary Stead Project: Compaq StorageWorks SAN Switch 8 Installation and Hardware Guide Comments:
Part Number: EK-BCP24-IA / 161355-001 File Name: E-CH4 DIAGNOSTICS.DOC Last Saved On: 9/30/99 10:27 AM
Table 4-4
diagShow Command Field Descriptions
Field
Description
Diagnostics Status
The title header displays the time diagShow was executed.
port#
The port number.
diags
Port’s current diagnostic status. Possible values include OK or
BAD.
state
Port’s current state. Possible values include UP (active) or
DN (inactive).
lm0-7 (8-port)
lm0-15 (16-port)
The frame counts of active ports. The display shows the
number of frames transmitted and received and low level
interface counts (LLI_errs).
Central Memory Status
Central memory status. Possible values include OK or FAULTY.
Total Diag Frames Tx
The total diagnostics frames transmitted (Tx) since boot. This
number usually corresponds to the total frames received (Rx)
but can differ because of failure modes.
Total Diag Frames Rx
The total diagnostics frames received (Rx) since boot. This
number usually corresponds to the total frames
transmitted (Tx) but can differ because of failure modes.
setGbicMode
The GBIC mode, when enabled, forces the Cross Port test or the Spin Silk test
to limit testing to only ports with detected GBIC modules. To enable
GBIC mode, execute the
setGbicMode 1
command.
switch:admin> setGbicMode 1
Figure 4-17. setGbicMode 1 command example
To disable GBIC mode, execute the
setGbicMode 0
command.
switch:admin> setGbicMode 0
Figure 4-18. setGbicMode 0 command example
