CommScope 3RU, Руководство пользователя

Страница: 26 / 54

ADCP-90-606 • Rev C • May 2020
Page 26
© 2020 CommScope . All Rights Reserved.
6.1 Unwinding Microcable from the External Spools
When cable lengths longer than the maximum capacity of the RapidReel cable spool trays is
ordered, the excess length for each RapidReel cable spool tray is coiled around an external
spool that is temporarily attached to the RapidReel cable spool tray.
The external spools and cable spool trays are then packaged with the empty Rapid panel shell in
a cardboard shipment container mounted on a pallet ( Figure 29 ).
Use the following procedure to unwind and route the cable from the external spool to an ODF or
fiber panel.
Figure 29. Hand Carrying Shipment Container
1. Position the shipping pallet as close as possible to the equipment rack where the panel
shell is to be installed. The shipment container has hand holes on either side intended for
use by two persons carrying the package as shown in
Figure 29 .
Note: If the microcable will exit the panel from the rear, place the pallet at the rear side of
the rack. If the microcable will exit the panel from the front, place the pallet at the front
side of the rack.