ComfortFlame.us.com
900568-00E
16
3. Locate the notches in bottom of front log (#3). Place front log on
grate fingers. Make sure notches of front log line up with grate
fingers
(see
Figure 27
).
4. Place left crossover log (#4) across logs #1, #2 and #3 fitting holes on
bottom of log #4 onto pin on front and middle logs as shown in
Figure
28
.
5. Place right crossover log (#5) in the same manner on right
side of logs
(see
Figure 28
).
Figure 26 - Installing Middle Log (#2) (Base may vary from
illustration)
Figure 25 - Installing Back Log (#1) (Base may vary from
illustration)
Hole in Grate
Base
Back
Log (#1)
Middle
Log (#2)
Cutout
Tab
Burner
"U" Bend
U-shaped
Slot
INSTALLATION
Continued
Figure 27 - Installing Front Log (#3) (Base may vary from
illustration)
Front Log (#3)
Grate Fingers
Notches
Figure 28 - Installing Crossover Logs
(#4 & #5) (Base may vary from illustration)
Pins
Crossover
Log (#5)
Crossover
Log (#4)
CAUTION: Do not remove the data plates attached
to the heater base assembly. The data plates contain
important warranty and safety information.
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
WARNING: After installation and periodically
thereafter, check to ensure that no flame comes in
contact with any log. With the heater set to High,
check to see if flame contact any log. If so, reposition
logs according to the log installation instructions in
this manual. Flames contacting logs will create soot.
WARNING: You must operate this fireplace with the
fireplace screen in place. Make sure fireplace screen
is in place before running fireplace.
INSTALLING LOGS
1. Locate pegs on bottom of back log (#1). Slide these pegs into
holes in grate base behind burner
(see
Figure 25
).
2. Place base of middle log (#2) in U-shaped slots of grate base in
front of back log. Cutout on right of middle log should fit over burner
(see
Figure 26
).
Make sure front of middle log is resting on tabs of
grate base and cutout area is centered over burner “U” bend.
