ComfortFlame.us.com
900568-00E
17
Figure 29 - Battery Install Hand-Held Remote Control
+
+
-
+
-
-
AAA
AAA
AAA
Battery Housing
Cover
Figure 31 - Battery Install Remote Control Receiver
Battery Housing
Cover
Cover Plate
Screws
Receiver
Figure 30 - Remote Display
Installing Cover Plate Onto Remote Receiver
1. Locate and remove cover plate from packaging.
2. Make sure sliding selector switch fits over switch on receiver.
3. Attach cover plate to receiver with 2 screws as shown in
Figure
31
.
4. See
Page 21
for instructions on programming remote receiver to
hand-held remote control.
NOTE:
For hand-held remote control to work, programming
(synchronizing) remote to receiver must be completed.
INSTALLATION
Continued
WARNING: Make sure your selector switch is in
OFF position before installing or changing batteries
in your hand-held remote or receiver.
INSTALLING BATTERIES IN REMOTE CONTROL AND RECEIVER
Installing Battery into Remote
1. Remove battery housing cover from back of hand-held remote.
2. Install 3 AAA batteries.
3. Replace battery housing cover.
When batteries are installed, the "little house" icon with current room
temperature will be displayed
(see
Figure 30
).
This icon will always
show in the control window as long as the batteries have power.
Installing Battery into Remote Receiver
1. Open lower louver to gain access to receiver.
2. Remove screws from cover plate.
3. Remove battery housing cover.
4. Install 4 AA batteries.
5. Replace battery housing cover.
6. Replace cover plate.
7. Close louver panel.
