Comet M1200E, Инструкция по эксплуатации

Страница: 41 / 50

IE-MLG-M1200E-01
41
Technical parameters
Power supply
The Multilogger is powered from batteries located under the removable cover
on the rear side of the device. An external power supply source can be also
connected to the Multilogger. When the device is connected to an external
power supply, the batteries are not used. Batteries can be recharged in the
device.
Batteries _______________________________________
Batteries:
3 x AA alkaline battery 1.5 V
Recommended accumulator type:
3x AA NiMH rechargeable batteries Sanyo ENELOOP
1,900 mAh, 1.2 V
________________________________________________________________________________________________
When NiMH accumulators are used, it is necessary to set
the charger in the device configuration, i.e. to set the Multilogger
for NiMH accumulators.
Operating time of fully charged NiMH batteries:
> 1 month in the standard measuring mode
approximately 6 month in the power saving mode
________________________________________________________________________________________________
Applies to Multilogger with fully charged batteries of the
recommended type; when the display backlight, LED indication
and audio signalization are turned off.
Current consumption when the Multilogger is turned off:
< 15 uA
Backing up of date and time in the Multilogger:
< 5 minutes after removing the batteries and with the
device turned off
________________________________________________________________________________________________
If the Multilogger is without a power for a longer time, the date
and time settings in the device could be lost and will have to be
set up again. When the Multilogger is connected to an external
power supply, the date and time are not lost when batteries are
removed.