Comet Labs NFPS2, Руководство пользователя

Страница: 9 / 93

Chapter3 Basic Installation
3.1 Connecting the Hardware
1. Make sure that your USB devices are switched off and that the Server’s Power
Adapter is disconnected.
2.
Connect the USB devices to the USB ports with the USB cables.
3. Connect the Server to the network with a twisted-pair category 5 cable,
10baseT or 100baseTX.
4.
Turn on the USB devices and make sure it is ready for use.
5. Connect the Power Adapter to the Server. The power indicator will light up and
USB1 and USB2 indicators will flash in turn. When the Link indicator lights up,
the Server is correctly connected to the network. When USB1 and USB2
indicators do not flash, the Server starts to work normally.
6.
If you connect USB HP printers to the Server, please press the Init button for 3
seconds on the Server once to print a page of Server configuration report.
3.2 Wireless connection
This section only applies to WFPS2.
3.2.1 Preliminary
„
Before you can access wireless network, wireless parameters should be set
correctly. You have to setup the first wireless parameter set through LAN
(wired) connection.
„
Wireless access can be set as 1. Infrastructure (station) mode, which need an
access point to route network messages, or 2. Ad-hoc mode, which connect
nearby wireless PC/devices with the same SSID (Service Set ID).
„
Wireless access can be secured by WEP64, WEP128, or WPA-PSK/TKIP.
„
In infrastructure mode, if network administrator wants to change any security
related parameters, WFPS2 should be changed first, and then access point.
If parameters mismatch causes wireless access is not allowed, you have to
modify those parameters through LAN connection.
„
In infrastructure mode, the maximal transfer rate is 54 MBits depending on
access point’s capability. In ad-hoc mode, only 802.11b (the maximal
transfer rate is 11 MBits) is allowed by specification.
3.2.2 Set Wireless Configuration Using MFP Server Control Center
1.
Install MFP Server Control Center. MFP Server Control Center is available in the
Comet Labs WFPS2 USB MFP Server Product CD.
2.
Start MFP Server Control Center and Auto-searching MFP server window will
appear.
9