Comelit 30001008, Техническое руководство

Страница: 10 / 40

10
Module connectors
Name Function
MOD1 IP communication expansion module connection
MOD2 Messages and voice control expansion module connection
MOD3 Reserved
MOD4 Reserved
MOD5 GSM communication expansion module connection
Terminal block M1
Pin Name Function
1 Earth symbol Connection for earthing the telephone line protection devices. Ensures their correct operation.
2 L1 Conductor 1 input from telephone line. Is connected directly to terminal TEL1
3 L2 Conductor 2 input from telephone line
4 TEL2 Conductor 2 output to telephone
5 TEL1 Conductor 1 output to telephone. Is connected directly to terminal L1
Terminal block M2
Pin Name Function
1 V+ BUS Power supply positive for 485 communication bus. Limited to 1.35A
2 V- Power supply negative All terminals marked V- are connected to each other
3 A RS485 data bus - A
4 B RS485 data bus - B
5 COM Connection for alarm relay exchange switchboard pin (RY1)
6 NC Normally closed connection for alarm relay (RY1). In standby the COM and NC terminals are kept closed together.
7 NO Normally open connection for alarm relay (RY1). When the relay is attracted, the COM and NO terminals are kept closed together.
8 V+ SIR Battery charge and power supply positive. Limited to 0.75A
9 TC2
Programmable block logic output. Permitted load 100mA. Polarity is determined by jumper JP5. If JP5 is set to OC, the output acts as an open collector: in
standby, it will not allow the passage of current, and if activated, it will close to earth. If JP5 is set to TC, however, in standby it will not allow the passage of current
and if activated, it will present a positive to the terminal.
10 TC1 As per TC1, but controlled by JP4
11 V- Power supply negative
Terminal block M3
Pin Name Function
1 V+ AUX Power supply positive for system sensors. Limited to 1.35A
2 I1 Programmable input zone 1.
3 I2 Programmable input zone 2.
4 V- Inputs common / Power supply negative
5 I3 Programmable input zone 3.
6 I4 Programmable input zone 4.
7 I5 Programmable input zone 5.
8 I6 Programmable input zone 6.
9 V- Inputs common / Power supply negative
10 I7 Programmable input zone 7.
11 I8 Programmable input zone 8.
12 V+ AUX Power supply positive for system sensors. Electrically connected to terminal 1 of the same terminal block. Shares its limitation.
13 V- Power supply negative
14 24H Programmable anti-tamper input.
Indicator lights
Name Function
DL1 Not present
DL2 Not present
DL3 Switchboard operating
DL4 Not present
DL5 Not present
Con fi guration jumpers
Name Function
JP1 If activated, enables 485 bus terminal resistor
JP2 Reserved
JP3 Reset (closing it and then opening it restarts the programme)
JP4 TC2 polarity: Open Collector (OC) or Positive Command on TC (TC)
JP5 TC1 polarity: Open Collector (OC) or Positive Command on TC (TC)
JP6 Restore initial con fi guration (see installation paragraph)
JP7 Service input
Power supply connection
Name Function
P1 PSU connector.