InteliLite
NT
– AMF20/25, SW version 2.2, ©ComAp – September 2014 15
IL-NT-AMF-2.2-Reference Guide.pdf
– localization technology
Hint:
GPRS and CSD services must be provided by your GSM/GPRS operator for successful operation.
Hint:
The GPRS and CSD connection should not be used for the firmware update process. Use instead a
wired connection like RS232, USB, RS485 or Ethernet via
IB-Lite
!
Hint:
It is necessary to power the controller and individually the IL-NT GPRS module as well.
Hint:
The controller can physically reset IL-NT-
GPRS module in case of “frozen” communication.
This
function is supported with IL-NT-GPRS (HW version 1.2) only!
Hint:
Quick guide how to start using this module is in chapter
or on ComAp webpage
http://www.comap.cz/products/detail/IL-NT-
Hint:
IL-NT G
PRS module doesn´t support a sending of e-mails.
Hint:
Any manipulation of the IL-NT GPRS module should be done only without voltage.
IL-NT AOUT8 Gauge driver module
IL-NT AOUT8 is optional plug-in card. Through this card controller can drive up to 8 VDO style
industrial/automotive gauges. Noncompensated gauges like 0-10V or 0-20mA are not supported.
Gauge type and value are configured in LiteEdit software. Any analog value from controller may be
shown in that way.
To insert the module, you must open the cover first (use screwdriver to open) and then insert the
module into slot. Once you have insert it, the module will snap under plastic teeth. It is supposed to be
installed permanently. Should you need to remove it, the safest way is to remove whole back cover
and then remove module manually.
Installing IL-NT AOUT8 module is similar to installing RS 232 module. The difference is that module
fits to “extension module” slot and after installing IL-NT AOUT8 you do not put back the small cover.
PC Installation Suite consist a set of prepared converting curves for basic usage of PWM outputs with
automotive gauges.
