Page
56
of
73
VastraJet K2
Step 6:
Once the glue has crossed the Glue Applicator unit, speed can be increased to 20. Using the cotton bud stick,
keep spreading the glue from the area where glue is in excess, to the area wherever the glue is less in quantity.
Fig 73: Spreading the Glue
Step 7:
Wherever the glue under the Glue Applicator is diminishing, pour the remaining glue over such areas.
Step 8:
When glue below the Glue Applicator seems to be diminishing at some areas, and becoming of higher
viscosity and uneven, person standing in front, should start spraying the cleaner liquid continuously till the end.
Fig 74: Spraying the Cleaner Liquid
Step 9:
Later the cleaner liquid spraying should be done throughout the belt, until the remaining glue appears to be
deactivated, due to mixing of cleaner liquid.
Step 10:
Remove the excess deactivated glue and throw in the waste bin. Wipe up only the area where liquid is
present, touching dry belt will damage the coating.
Step 11:
Take out the Glue Applicator unit.
Step 12:
Once excess glue is removed, run the glue cycle for 30-50 min (turn on print dryer and move belt using the
washing System screen).
Step 13:
Leave machine idle for 4 hours to let glue dry and set. (Next glue coat has to be done only after resting
period of 4 hours) Above process has to be repeated for every glue coat process.
