Cold Jet E-CO2 150, Руководство оператора

Страница: 18 / 46

14
Setting Up the E-CO
2
150
WARNING Improper installation of hoses and adapters to the E-CO
2
150 can cause damage
to the machine.
WARNING Do not use the machine if any important parts of the machine are damaged, (e.g.
safety devices, high pressure hoses, applicator).
These instructions will apply to all three models of Cold Jet blasters. The illustrations may or may not
correspond to the dry ice blasting machine you are using.
It is recommended, for trouble free operation, that the compressed air be run through a Cold Jet
aftercooler or an air dryer to remove as much moisture as possible from the blast air supply. Moisture
is the enemy of both dry ice and abrasive media. It can cause icing up and abrasive clumping – both
leading to feeding and blasting problems.
Connecting to the compressed air source
WARNING NEVER reach into the Pop-up opening while filling the E-CO
2
150. It can close
without warning causing severe injury or death.
WARNING NEVER use abrasives containing silica or beryllium.
WARNING NEVER fill the E-CO
2
150 with the inlet valve in the open position. ALWAYS close
the valve before filling.
WARNING Electrically conductive media shall not be used with the E-CO
2
150 using electric
remote control systems without changing to sealed strain relief connectors.
WARNING NEVER attempt to transport the E-CO
2
150 when it contains abrasive.
WARNING NEVER operate the E-CO
2
150 without a remote control system.
WARNING Use only Cold Jet supplied remote control systems as others may start or stop the
E-CO
2
150 without warning.
WARNING NEVER reverse or make modifications to the remote control system.
WARNING ALWAYS use caution around electric sources to avoid electric shock. Do not
operate electrical remote controlled E-CO
2
150 systems in wet or hazardous
environments.