Cold Jet AERO2 PLT 60, Руководство оператора

Страница: 29 / 56

23
Follow the instructions below to start the blasting job:
1. On the control panel, press the red power button to turn the PLT 60 on. The power button
will turn blue.
Figure 7: Power Button ON Status
2. Purge the system:
Always purge the system with compressed air during start-up, after
breaks and before loading dry ice. This will remove any accumulated
moisture, water and ice in the system
a. On the applicator, press the air+ice button (II) to activate (green light indicates ON and
pressing the II button again will set the system to OFF).
b. Using the rotary encoder dial, navigate to the feed rate indicator on the home screen
and adjust it to the maximum setting.
c. On the applicator, pull the trigger and blast for 10 seconds.
d. Set the feed rate to its minimal setting.
3. Load or reload dry ice into the hopper:
a. On the applicator, press the air+ice button (II) to deactivate (green light OFF). This will
also deactivate the applicator.
b. On the PLT 60, open the hopper lid leaving the safeguard grate in place.
Opening the safeguard grate will cause the PLT 60 to shut down
automatically. The grate is a safeguard to prevent coming into contact
with the doser at the bottom of the hopper