Coemar Infinity Spot XL, Инструкция по эксплуатации

Страница: 9 / 29

English
11
When signal arrives from a DMX 512 console with Cannon XLR5 ( 5 poles) pins 4 and 5 must not be connected.
WARNING !
Make sure that screening and conductors are not in contact one another or with the metal housing of the connector.
Pin n# 1 and housing must never be connected to the unit power supply.
6.1 Connection through ArtNet protocol.
The ArtNet protocol allows enabled projectors to operate and to be seen as a normal network device, such as a standard P.C.
connected to a company network.
Infinity Spot XL leaves the factory ready to be connected to an ArtNet network without any further settings. Just connect the
projector by means of the specific RJ45 connector located on the side of the DMX connectors and the relative patch to a common
HUB Ethernet which will be connected to an ArtNet controller. Each Coemar projector has its own IP address, therefore it is not
necessary to set it when connecting it to the network. Should it be necessary to modify the IP address for reasons related to the
net, each Coemar projector allows customization. In order to modify the net setting, access the MAIN FUNCTION/PROJECTOR
CONTROL MODE/ARTNET ONLY menu ( alternatively, Artnet to DMX) /CUSTOM IP ADDRESS (see complete menu, art. 8.3).
7. Turning on the projector
After having followed the preceding steps, proceed with the power supply and turn on the projector via the main power switch.
The display will show a short welcome message and the software version installed on the internal microprocessors:
Software version currently installed on the main board (LCD) and
on motor cards (MOTOR)
The projector will perform the reset function on all motors. This operation will last a few seconds, thus allowing the digital control
motors to correctly position themselves. Then the display will turn on in a fixed mode, indicating the correct DMX 512 signal
reception.
During the reset function the display will blink
for a few seconds
…
.. then the DMX address of the projector will
appear.
If the address continues to blink
and the “NO DMX SIGNAL” message appears, it means that the DMX signal has not been
received. Check the connection cable and the mixer functioning.
INFINITY SPOT XL
-SW LCD ver. XX
-SW MOTORS ver.XX