Coemar Infinity Spot XL, Инструкция по эксплуатации

Страница: 10 / 29

English
12
7.1 DMX address of the projector
NB: The following section is valid only in the case where Infinity Spot XL is controlled by the signal DMX 512.
Each projector utilises 31 address channels (16 bit) for its complete operation and is controlled by a DMX 512 signal (for further
information, see section 7.2, DMX functions).
When powered up initially, each projector will show A001, which indicates DMX address 001; a projector thus addressed will
respond to commands of channel 1 to 31 from your DMX 512 controller. A second unit must
be
addressed as A032, a third as
A063 and so on. The operation must be carried out every Infinity Spot XL which has an address different from A001.
Altering DMX address
1. Press the + or - buttons until the display shows the required DMX number. The digits on the display will blink to indicate that the
variation has not been registered.
2. Press the
“enter” button to confirm your selection. The digits on the display panel will cease to flash and the projector will now
respond to the new address.
N.B. : by holding the + or - buttons down the scrolling will be faster, thus allowing a faster selection.
WARNING!
If you alter the DMX address with no DMX signal connected, the digits on the display panel will continue to flash
even after you have pressed ENTER button to confirm the address.