Coemar Infinity Spot XL, Инструкция по эксплуатации

Страница: 15 / 29

English
17
8.3 Main functions
The projector gives the opportunity to change and customize some functional settings.
MAIN FUNCTIONS
PAN/TILT
CMY .CTO
SETTING
GOBOS
IRIS
FANS MODE
CONTROL
LAMP STRIKE
DMX
RESET
RECALL DEFAULT
SETTINGS
ZAP EFFECT
ENABLE
ID CODE
TEST MOTORS
PROJECTOR
CONTROL MODE
-STANDARD
-SPECIAL
RESOLUTION
-8 bit
-16 bit
-LINEAR
-PULSE
-NORMAL
-HIGH
-ON
-STANDARD
-ALL
-PAN/TILT ONLY
-EFFECT ONLY
-SURE ?
-ON
-OFF
from 1 to n
see diagram in the following
page.
Allows the complete management of the horizontal and vertical movements.
Allows to choose the gobos's working resolution at 8 or 16 bit (see the DMX
table for further information).
Enables or disables the iris pulse effect. (see DMX table).
NORMAL: the fan functioning is controlled by the electronic board
according to the measured temperature. HIGH: fans always ON.
STANDARD: lamp switch ON/OFF is controlled by the DMX signal. ON: the
lamp is always ON independently from the DMX signal.
Performs the reset of all motors, of pan/tilt only or of only the effects. By
pressing ENTER and MENU at the reset starting, access to the SPECIAL
MODE is possible.
Restore to the default values all functional settings except for alignment,
address and operation time.
Enable or disable the "zap" effect.
Sets the projector ID code by pressing the buttons + and - .
PAN
TILT
DIMMER
SHUTTER
IRIS
GOBO WHEEL 1
GOBO ROTATION 1
COLOR WHEEL
CYAN
MAGENTA
YELLOW
GOBO WHEEL 2
ZOOM
FOCUS
ZAP EFFECT
SAVE ALL
Allow to move and check the functioning of every motor without using the
DMX signal.
SAVE ALL: saves all settings for the next start up of the fixture.
DMX ONLY
ARTNET ONLY
ARTNET TO DMX
Default IP address
CustomIP address
Universe address
MAC address
Default IP address
CustomIP address
Universe address
MAC address
Allows to choose an alternative movement curve for colors and CTO.
Allows to set the projector control
mode (see paragraph concerning
ARTNET functions).
DIMMER
SETTING
-STANDARD
-SPECIAL
Allows to choose an alternative movement curve for the dimmer.
GOBO WHEEL 3
GOBO ROTATION 2
GOBO ROTATION 3
CTO