Coemar Infinity Spot XL, Инструкция по эксплуатации

Страница: 7 / 29

English
9
For installations on a reticular structure,
we recommend using specific “C” hooks, suitable for supporting the weight. Normally, the
“C” hooks are tightened in the central hole of the cam-lock brackets, as shown in the picture below.
WARNING !
Always make sure that both the structure and the fixing devices (screws, clamps etc.) are suitable for holding the
weight of the unit.
The structure must also be sufficiently rigid so as not to move or shake whilst the
Infinity Spot XL projector moves during its
operation. Make sure that the supporting structure is not subject to torsion.
Do not install the projector in locations readily accessible by unauthorised or untrained personnel who is not aware of these safety
instructions.
4.2 Safety connection
If the Infinity Spot XL is fixed to a structure, the use of a safety chain is recommended in order to meet the current relevant safety
standards. The safety chain must
pass through the holes “A” and then fixed to the structure itself.
If using steel wires or chains which have not been manufactured by Coemar, make sure that they are suitable for holding the weight
of the unit.
5. Powering up
5.1 Connecting to mains power
Mains cable characteristics
The mains cable provided is a special thermally resistant cable, complying with the most recent international standards. It is VDE
approved and complies with IEC norms, IEC 331,IEC 332 3C,CEI 20 35.
NB: In case of cable replacement, similar cable with comparable thermal resistant qualities must be used exclusively (cable 3x1.5 ø
external 10 mm, rated voltage 300/500V, test voltage 2KV, operation temperature -40°C+ 180°C, Coemar CV5309).
A