English
27
Fans and air passages
The fans and air passages must be cleaned approximately every 6 weeks; the period for this periodic cleaning will depend, of course,
upon the conditions in which the projector is operating. Suitable instruments for performing this type of maintenance are a brush and
a common vacuum cleaner or an air compressor.
If necessary do not hesitate to carry this out even after a shorter period of time.
11.2 Periodic maintenance
Lamp
Check the lamp and replace it if there is any observable damage or deformation due to heat (check with the resettable counter).
Mechanical parts
Periodically check all mechanical devices for wear and tear; gears, guides, belts, etc., replacing them if necessary. Check the projec-
tor is not mechanically damaged. If necessary, replace the worn parts.
Check the tension of the belts and adjust them if necesary.
Electrical components
Check all electrical components for correct earthing and proper attachment of all connectors. Press the connectors if necessary and
reposition as before.
11.3 Fuse replacement
Locate the fuse, which protects the lamp and electronics, in the base of the
Infinity Spot S
.
Using a multimeter, test the condition of the fuse, replacing it with one of equivalent type if necessary.
12. Spare parts
All the components of the
Infinity Spot S
are available as replacement spares from your authorised Coemar service centre. Accurate
description of the fixture, model number, and type will assist us in providing for your requirements in an efficient and effective manner.
11. Maintenance
11.1 Periodic cleaning
Lenses and filters
Even a fine layer of dust can reduce the luminous output and alter the compactness of the beam. Regularly clean all filters and len-
ses using a soft cotton cloth, dampened with a specialist lens cleaning solution.
10.11 How to replace effects
1.
Lift and gently extract from the wheel the support which contains the effect you are going to replace.
2.
Slide the new support under the spring, making sure that it enters in place through the two pins on the back of the support.
Coemar code
Description
CO9109
Optional Camlock bracket common to other Coemar products
