English
15
8.3. Main functions
This section gives the opportunity to change and customize some functional settings of the fixture.
MAIN FUNCTIONS
PAN/TILT
CMY SETTINGS
GOBOS
IRIS
FANS MODE CONTROL
LAMP STRIKE DMX
RESET
RECALL DEFAULT
SETTINGS
ZAP EFFECT ENABLE
ID CODE
TEST MOTORS
PROJECTOR CONTROL
MODE
-STANDARD
-SPECIAL
RESOLUTION
-8 bit
-16 bit
-LINEAR
-PULSE
-NORMAL
-HIGH
-ON
-STANDARD
-ALL
-PAN/TILT ONLY
-EFFECT ONLY
-SURE ?
-ON
-OFF
from
1
to
n°
see diagram in the next page.
It allows the complete management of the horizontal and vertical
movements.
It allows to choose the gobo's working resolution. (please, see DMX
chart).
Enables or disables the iris pulse effect.
(please, see DMX chart).
In NORMAL position the control of the fans is made by pcb in function of
internal temperature, in HIGH position the fans are always at full power.
In STANDARD mode the on/off state of the lamp is controlled by DMX
signal; otherwise, in ON position, the lamp remains always on (please,
see DMX chart).
It performs the reset function of the fixture.
Pressing ENTER and MENU buttons when reset starts, It will access
SPECIAL MODE (see it at pag. 19).
Restores all functional settings (excepts for address, motors, tuning and
odometers) to default values.
Enables or disables the lamp's "zap effect".
Lets you set the ID code of the fixture by using + or - buttons.
PAN
TILT
DIMMER
SHUTTER
IRIS
GOBO WHEEL 1
GOBO ROTATION 1
COLOR WHEEL
CYAN
MAGENTA
YELLOW
GOBO WHEEL 2
ZOOM
FOCUS
ZAP EFFECT
SAVE ALL
It allows to move and check every single motor without using DMX
signal. SAVE ALL allows to store the motors position until next fixture's
start.
DMX ONLY
ARTNET ONLY
ARTNET TO DMX
Default IP address
CustomIP address
Universe address
MAC address
Default IP address
CustomIP address
Universe address
MAC address
It allows to choose an alternative colour insertion curve.
It allows to set the fixture's control mode
(please, see ARTNET functions chapter).
PRISM WHEEL
PRISM ROTATION
