Cobra CX50 2014 5R King, Руководство пользователя

Страница: 60 / 79

58
CAUTION:
Damage may occur if one attempts to install the water pump and the device is not
orientated correctly. If the tool does not sit flat against the cases, the orientation of the
tool to the engine is not correct. Make sure that the top alignment pin is in the 2
nd
unthreaded hole, the bottom alignment pin is also in the 2
nd
unthreaded hole, and that
the relief for the stator bolt head is oriented toward the stator.
10. Hold the installation tool firmly against the engine case and tap on the end of the
water pump shaft with a dead blow hammer until the insertion punch is needed.
11. Continue driving the assembly with the punch until the head is flush.
NOTE:
The insertion punch is 0.010” (0.25mm) longer than the housing so as to seat
the water pump assembly just in from the case surface.
12. The assembly is installed properly when the retaining screw can be tightened and it
does not cause a bind on the spinning shaft (use medium strength thread lock on the
retainer screw).
NOTE: It may be necessary to tap the water pump shaft in (hammer) and out (with
slide hammer) to insure proper free operation of the shaft.
13. Reinstall the pulley, belt and fan cover using a 3mm hex key to stop the rotation of
the water pump assembly while tightening with medium strength thread lock to 10 ft-
lb (14Nm).