Cobra CX50 2014 5R King, Руководство пользователя

Страница: 15 / 79

13
Brake Bleeding Procedure
Tools Required:

Front: T10 Torx bit/driver, Cobra bleed kit (BCKG0031)

Rear: 3mm hex key (Allen wrench, T10 Torx bit/driver, Cobra bleed
kit(BCKG0031)
Procedure:

Remove the brake fluid reservoir cover.

Fill the syringe half full with brake fluid.

Remove the brake caliper bleed screw.

Attach the syringe to the brake caliper bleed access. Keep the syringe oriented
as not to allow air from the syringe into the system.

Using the syringe pull fluid through the system. Use caution not to let the fluid in
the reservoir to become low and introduce air into the system.

Using the syringe push fluid back into the system until the reservoir is full.

Repeat these actions of pulling and pushing fluid through the system a few times.

With the reservoir full, engage the brake lever/pedal and hold it there as if
engaging the brakes.

While doing this pull on the plunger of the syringe. Doing this will cause a
vacuum in the system. The vacuum will swell the air bubbles which assist in them
moving throughout the system.

Continue pulling a vacuum and release the brake lever/pedal (careful not to allow
the reservoir to become empty).

Once again engage the brakes while continuing to pull a vacuum.

When the reservoir is almost empty stop and push fluid back into the system.

Repeat these steps with the vacuum until no more air bubbles can be removed
from the system.

Remove the syringe. Be sure to keep the caliper below the level of the reservoir
to allow the fluid to run out of the caliper and not allowing air into the system.

Reinstall the bleed screw, being sure that the ring is in place.

Fill the reservoir with fluid (the fluid should be full enough that the fluid spills out
when placing the lid on) and replace the cover.