Cobra CX50 2014 5R King, Руководство пользователя

Страница: 11 / 79

9
Be sure the fuel tank and carburetor have been removed and safely located away
from the welding process.
9.
The frame is 4130 Chrome Moly and it is important to weld it with the proper rod
and heat settings set as light as possible. Cobra recommends replacing the frame
with a new one if the old one becomes damaged. Use ER70S6 filler if welding on
the frame.
10. If your kick-starter lever does not return properly, first try loosening the six
kick/clutch cover screws ½ turn. Hold the kick lever ½ way down while retightening
the six screws starting for the center and working out
11. Inspect CFD slip torque after the 2
nd
ride and then again after the 6
th
ride. After this
follow the recommended schedule below.
12. Check proper clutch engagement before and after each ride. If the clutch is
engaging properly DO NOT feel the need to take the clutch apart to; measure the
spring stack, clean the stack, replace the springs, etc... Cobra has worked very
hard to make a clutch that is low maintenance and so only take it apart if it NEEDS
to be maintained.
Schedule

Prior to each ride
o
Check the air filter (clean and re-oil as necessary).
o
Insure the smooth operation of the throttle cable (throttle soundly ‘clacks’
shut).
o
Check for frayed strands of the throttle cable inside the throttle housing and
replace if necessary.
o
Check for adequate tire pressures and adjust if necessary.
o
Check all nuts and bolts for proper torque and re-torque if necessary.
o
Spray all moving parts with WD40 or other light oil.
o
Check drive chain for

Proper tension and adjust if necessary.

Adequate lubrication and lubricate if necessary.
o
Insure that the ignition stator and rotor are clean and dry.
o
Check the frame for cracks in the metal or cracks in the paint that might
indicate that the me
tal has been stressed beyond it’s safe limits. Replace or
get properly rewelded as necessary.
o
Check the rims for signs of stress, like cracks around the rim, spokes and
hub.
o
Equalize the pressure in the forks with atmosphere.

Every 2 hours of operation
o
Replace the transmission oil.
o
Check the CFD torque.

Every 10 hours of operation
o
Replace the fork oil.
o
Have the shock oil replaced by a Certified Cobra Mechanic.