CNC CNCWL- 5136-XN, Руководство оператора

Страница: 18 / 30

CNCWL-XN Series Machines
Tuning the Optics
✎Note: Before any machine leaves our facility, itis put through a quality assurance process andthese optics
are already aligned and ready for use. Therefore, there is no need for adjustment to the mirrors, tube, or
bracket.
There is a possibility that the optics may have shifted in transit but, we recommend calling technical support
prior to making ANY adjustments.
The laser tube and optics are the heart of the machine, it is important to understand the basics which will
allow you to get the most out of your machine. Once tuned, the laser machine should stay aligned for months
of work. Check the alignment of the optics once a month to insure no bumping or mechanical failure has
occurred.
By studying the diagram in Figure 25 you can see the simplicity of the system. There is one long glass tube,
three small mirrors, and the laser head. The laser beam travels in a straight line, the laser tube in the rear will
need to be adjusted to hit the mirror (#1) in the dead center, then adjust mirror (#1) to hit mirror (#2) in the
dead center. Finally, adjust mirror (#2) to hit the dead center of the mirror in the laser head.
⚠Be careful with this procedure! Never have the machine on while working around the lasertube. Make an
adjustment, then turn on the laser and fire a test shot by pressing the “Pulse” key located on the LED Control
Panel.
Tube Bracket:
The Tube Bracket, which holds the glass tube safely and securely. The bracket has
two adjustment parameters for the tube, which is vertically or horizontally in the
cabinet. All adjustments are accomplished using the Height Adjustment Wheel
(vertical adjustment) and un- screwing/re-screwing the four Allen screws at the
base of the tube bracket (horizontal adjustment).
The horizontal adjustment screws are under the bracket and through the cabinet
metal. Once the Allen screws are loose, you will have about .5-inch travel front to
back. Both brackets have slotted holes in the cabinet for this purpose.
The vertical adjustment is quite simple. First, use an Allen key to loosen the
vertical adjustment Allen screws and then lower or raise the upper bracket using
the height adjustment wheel. With these two adjustment parameters, the process
of aligning the tube to hit the first mirror will be much easier!
CNC Warehouse LLC 14