Club Car V-GLIDE, Дополнение к руководству по обслуживанию

Страница: 33 / 112

ELECTRICAL COMPONENTS Forward/Reverse Anti-Arcing Limit Switch
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement Page 12-3
12
FORWARD/REVERSE ANTI-ARCING LIMIT SWITCH
See General Warning, Section 10, Page 10-1.
The Forward/Reverse anti-arcing limit switch is located on the Forward/Reverse switch and is activated by a
cam on the Forward/Reverse switch rotor.
Testing the Anti-arcing Limit Switch
See Test Procedure 3, Section 11, Page 11-9.
Anti-arcing Limit Switch Removal
1. Remove the nuts, lock washers, and screws attaching the anti-arcing limit switch to the Forward/Reverse
switch (Figure 12-3, Page 12-3).
Anti-arcing Limit Switch Installation
1. Position the anti-arcing limit switch (2) on the Forward/Reverse switch housing and install the screws,
lock washers, and nuts. Tighten the screws to 5 in-lb (0.6 N·m) (Figure 12-3, Page 12-3).
2. Connect the blue wire (9) to the common (COM) terminal (6) and the yellow wire (8) to the normally open
(NO) terminal (7) (Figure 12-3, Page 12-3).
3. After installation, make sure the switch makes an audible click (makes and breaks contact) when the for-
ward and reverse rotor is turned. If it does not click, inspect the forward and reverse rotor and limit switch
for damage.
ACCELERATOR PEDAL LIMIT SWITCH
See General Warning, Section 10, Page 10-1.
Testing the Accelerator Pedal Limit Switch
See Test Procedure 4, Section 11, Page 11-9.
Figure 12-3 Forward/Reverse Anti-arcing Limit Switch
FRONT
PANEL
2
3
TYPICAL 2
PLACES
4
5
TYPICAL 2
PLACES
1
7
6
9
8