Club Car V-GLIDE, Дополнение к руководству по обслуживанию

Страница: 80 / 112

TRANSAXLE (TYPE G) Axle Bearing and Shaft
Page 16a-2 2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement
16A
Axle Shaft and Oil Seal Removal, Continued:
3. Use 90° internal snap ring pliers to remove the internal retaining ring (6) from the axle tube
(Figure 16a-5, Page 16a-3). See also Figure 16a-1, Page 16a-2.
4. Remove the axle, retaining ring, and bearing assembly by pulling the axle straight out of the housing.
5. If necessary, remove the axle oil seal and adapter ring.
5.1. Use a bearing puller (CCI P/N 1016417) to remove the axle seal and adapter ring from the axle tube
(Figure 16a-2, Page 16a-2). See following CAUTION and NOTE.
CAUTION
• Do not scar or damage the inside surfaces of the tube when removing the oil seal and adapter
ring. A damaged tube might have to be replaced.
NOTE: Do not discard the adapter ring. If the adapter ring is lost or damaged, the axle tube will have to be
replaced.
5.2. Use a press to separate the axle oil seal (15) from the adapter ring (39) (Figure 16a-3,
Page 16a-2). Retain the adapter ring and discard the oil seal.
6. Inspect the axle shaft assembly to be sure the bearing and collar have not slipped and are still seated
against the shoulder on the axle shaft.
7. Inspect bearing (5) (Figure 16a-5, Page 16a-3). If the bearing in a Type G transaxle is worn or damaged,
the entire axle shaft assembly (1 or 2) must be replaced.
Figure 16a-1 Axle Tube Figure 16a-2 Axle Seal and Adapter Ring Removal
Figure 16a-3 Axle Seal and Adapter Ring Figure 16a-4 Axle Seal and Adapter Ring Installation
ADAPTER
RING LIP
15
39