Club Car Carryall 295 SE, Руководство по техническому обслуживанию и ремонту

Страница: 347 / 456

DIESEL ENGINE, MUFFLER, FUEL SYSTEM, AND
CLUTCHES Engine Control Linkages
16
2187
Figure 16-21 Diesel Probe Fuel Line Clamp On Engine
2188
Figure 16-22 Diesel Probe Battery Cable Clamp
3. Secure the fuel line probe clamp to the clean area of the fuel injector line (Figure 16-21, Page 16-21) .
4. Secure the negative (–) line clamp to the negative (–) battery post (Figure 16-22, Page 16-21) .
5. Secure the diesel probe to the tachometer (Figure 16-19, Page 16-20) . See following NOTE.
NOTE: It will be necessary to cut the wire attached to the adjustment screws. The manufacturer recommends that a
new wire be secured to the screws after new RPM settings are established.
6. Turn the key switch to start and run the engine at idle. Measure the RPM with the tachometer and diesel probe
attachment. Note the RPM reading. The correct idle RPM setting for this diesel engine is 1250 RPM ± 25.
7. Turn the key switch OFF. Turn the low-speed adjustment screw 1/4 turn clockwise to raise the RPM, or
counterclockwise to lower the RPM
(Figure 16-23, Page 16-21) .
8. Turn the key switch to start the engine and allow it to idle. Measure the RPM. Repeat steps 6 and 7 until the idle
RPM is correct.
See following NOTE.
2189
Figure 16-23 Idle Throttle Adjustment Screw
2190
Figure 16-24 High-Speed Throttle Adjustment Screw
High-Speed RPM Adjustment
1. Clean paint, grease, and dirt from any one of the three fuel injector lines (Figure 16-20, Page 16-20) . See
following NOTE.
2008-2012 All-Wheel Drive Maintenance and Service Manual Page 16-21