Club Car 1998 DS, Дополнение к руководству по обслуживанию и ремонту

Страница: 97 / 132

POWERDRIVE BATTERY CHARGER Charger Repairs
1998/1999 PowerDrive Plus Vehicle Maintenance and Service Supplement Page 14-25
14
Charger Relay Installation
1. Install in reverse order of removal. Connect wires as shown in Figure 14-21, Page 14-24 . Tighten nut con-
necting relay to charger base to 18 in.lb (2.0 N-m).
CHARGER AC CIRCUIT BREAKER
AC Circuit Breaker Removal
1. Disconnect the AC and DC cords. See WARNING on page 14-21.
2. Remove the charger cover.
3. Disconnect the two black wires attached to circuit breaker (Figure 14-21, Page 14-24) .
4. With a pair of pliers, squeeze in the retaining tabs on the sides of the circuit breaker and remove the circuit
breaker through its mounting hole in the face of the charger (Figure 14-21, Page 14-24) .
AC Circuit Breaker Installation
1. Install in reverse order of removal.
CHARGER AC CORD
AC Cord Removal
1. Disconnect the AC and DC cords. See WARNING on page 14-20.
2. Remove the charger cover.
3. Disconnect the AC cord black wire at the circuit breaker (Figure 14-21, Page 14-24) .
4. Disconnect the AC cord white wire at the primary coil tan wire (Figure 14-21, Page 14-24) .
5. Disconnect the AC cord green wire at the charger base (Figure 14-21, Page 14-24) .
6. Use a pair of pliers to grip the strain relief bushing and remove it and the AC cord from the charger.
AC Cord Installation
1. Insert the black, white, and green leads of the new AC cord into the charger through the hole in the charger
face (Figure 14-21, Page 14-24) .
2. Connect the black wire to the circuit breaker, the white wire to the primary coil, and the green wire to the
charger base (Figure 14-21, Page 14-24). See following NOTE .
3. Position the strain relief bushing on the AC cord.
4. Using pliers, install the strain relief bushing and AC cord into the mounting hole in the charger face.
5. Install the charger cover.
• MAKE SURE THE GREEN (GROUND) WIRE IS TIGHTLY SECURED TO THE CHARGER BASE.
NOTE