Club Car 1998 DS, Дополнение к руководству по обслуживанию и ремонту

Страница: 89 / 132

POWERDRIVE BATTERY CHARGER Test Procedures
1998/1999 PowerDrive Plus Vehicle Maintenance and Service Supplement Page 14-17
14
6. If the transformer output measurements are 86 volts AC or higher, disconnect the AC plug from its outlet.
7. If the voltage readings are normal, the transformer is good. Refer to Test Procedure 5 for further tests of the
DC circuit.
Test Procedure 7 - Battery State of Charge
1. After the charger has shut off, disconnect the DC charger plug for approximately 20 seconds and then recon-
nect it. The ammeter should jump to 14 to 18 amps and then taper to below 5 amps within 15 minutes. If it
does taper to below 5 amps within 15 minutes, batteries are fully charged and the charger is functioning
properly.
2. If the charger does not taper to below 5 amps within 15 minutes, batteries may not be receiving a full charge
and the onboard computer should be checked. See Test Procedure 2 .
Test Procedure 8 - Continuity
AC Cord and Plug
Check continuity of the AC cord (Figure 14-17, Page 14-18).
1. Disconnect the AC cord from its outlet and the DC plug from the receptacle, then remove the charger cover.
2. Disconnect black wire (1) of AC cord from charger AC circuit breaker (3) (Figure 14-17, Page 14-18) .
3. Disconnect green wire (2) from charger case and position it so it does not touch any metal part of the
charger (Figure 14-17, Page 14-18) .
• DO NOT ALLOW SECONDARY COIL LEADS TO TOUCH ONE ANOTHER. THERE ARE APPROXIMATELY 120 VOLTS
PRESENT.
Figure 14-16 Transformer Test Wiring Diagram
• OLD BATTERIES NEAR THE END OF USEFUL SERVICE MAY NOT TAPER TO BELOW 5 AMPS. SEE SECTION 13–
BATTERIES .
DANGER
DC CORDSET
RED
RED
BLUE
BLACK
BLACK
BLACK
BLACK
BLACK
15 AMP
AC CIRCUIT
BREAKER
AC INPUT PLUG
AC CORDSET
GREEN
CASE
GROUND
WHITE TAN
TAN
TAN
TAN TAN
HEAT SINK
ASSEMBLY
FUSE
ASS'Y
AMMETER
TRANSFORMER
RELAY
3
4
2
1
5
7
6
PRIMARY
COIL
SECONDARY
COIL
NOTE