Club Car 1998 DS, Дополнение к руководству по обслуживанию и ремонту

Страница: 40 / 132

ELECTRICAL COMPONENTS Accelerator Pedal Limit Switch
Page 12-4 1998/1999 PowerDrive Plus Maintenance and Service Supplement
12
ACCELERATOR PEDAL LIMIT SWITCH
Read DANGER and WARNING on page 12-1.
Testing the Accelerator Pedal Limit Switch
See Test Procedure 5, Section 11, Page 11-16.
Accelerator Pedal Limit Switch Removal
1. Place Tow/Run switch in the TOW position, disconnect batteries (negative cable first) (Figure 12-1, Page 12-
2) and discharge speed controller.
2. Remove the No. 5 and No. 6 batteries from the vehicle.
3. Remove the cover from the wiper switch housing.
4. Disconnect the accelerator rod from the ball stud on the wiper switch.
5. Remove and retain the screws, lock washers, and nuts attaching the limit switch to the wiper switch.
6. Disconnect the green/white and blue wires from the limit switch.
Accelerator Pedal Limit Switch Installation
1. Position the Accelerator Pedal Limit switch on the wiper switch body and install the mounting screws, lock
washers, and nuts. Tighten the screws to 5 in.lb (0.6 N-m).
2. Connect the accelerator rod ball joint to the ball stud on the wiper switch.
3. Connect the green/white wire to the normally closed (NC) terminal and the blue wire to the common (COM)
terminal of the limit switch. The normally open (NO) terminal should have
no
wire attached.
4. Install the cover on the wiper switch (make sure all three tabs snap into place).
5. Install and connect the No. 5 and No. 6 batteries, leaving the No. 6 negative (–) post disconnected.
6. Connect battery cables to battery No. 1 positive (+) first, then connect cable to battery No. 6 negative (–). Tighten ter-
minals to 110 in.lb (12.4 N-m).
7. Place Tow/Run switch in RUN.
Figure 12-3 Forward/Reverse Rocker Switch
F
3
2
1
TYPICAL
3 PLACES
5
4
6