Club Car 1998 DS, Дополнение к руководству по обслуживанию и ремонту

Страница: 54 / 132

ELECTRICAL COMPONENTS Energy Displacement Module
Page 12-18 1998/1999 PowerDrive Plus Maintenance and Service Supplement
12
Testing the Battery Warning Light, Continued:
5. Install the wedgelock in the six-pin connector housing and reconnect the six-pin connector plug. Place the
Tow/Run switch in the RUN position and the battery light should illuminate. If the light does not illuminate,
replace the battery warning light assembly.
Battery Warning Light Removal
1. Place Tow/Run switch in TOW and disconnect the battery wires as shown (Figure 12-1, Page 12-2) .
2. Remove center dash. See Remove Center Dash on Page 12-2 .
3. Disconnect the brown wire at the spade terminal and remove the orange/white wire from the key switch. Do
not allow wires to touch.
4. Depress the two retaining tabs and remove the light from the center dash.
Battery Warning Light Installation
1. Install in reverse order of removal. Reconnect battery wires (positive cable first) and tighten to 110 in.lb (12.4
N-m). Place Tow/Run switch in the RUN position.
ENERGY DISPLACEMENT MODULE
Read DANGER and WARNING on page 12-1.
Energy Displacement Module Removal
1. Place Tow/Run switch in the TOW position and disconnect battery cables (Figure 12-1, Page 12-2) .
2. Remove the two 1/4 in. nuts, lock washers, flat washers and bolts that secure the coil to the mounting tabs
and remove coil (Figure 12-5, Page 12-6) .
Energy Displacement Module Installation
1. Installation is reverse of removal. Position the coil ends as shown in Figure 12-5, Page 12-6 and tighten the nuts
(6) to 75 in.lb (8.5 N-m). See also Figure 12-14, Page 12-18. See following CAUTION.
2. Reconnect battery cables (positive cable first) and tighten to 110 in.lb (12.4 N-m). Place the Tow/Run switch in
the RUN position.
• BE SURE ALL WIRES ARE SECURED IN PLACE SO THEY DO NOT COME INTO CONTACT WITH THE COIL.
Figure 12-14 Energy Displacement Module
CAUTION
RESISTOR COILS
DYNAMIC BRAKING
SOLENOID