Club Car 1997 DS, Дополнение к руководству по обслуживанию

Страница: 77 / 164

Page 69
G
10
17. Connect the engine kill switch wire (18 gauge white/black stripe) to the bullet connector at the lower
right front of the engine (Figure 10-95).
18. Connect the engine oil level sending unit wire (18 gauge yellow) to the sending unit located on the
engine, beneath the muffler (Figure 10-96).
19. Connect 6 gauge white wire to the F2 post, the 6 gauge black ground wire to the A2 post, and the 16
gauge yellow wire to the DF post on the starter/generator (Figure 10-97).
20. Position the shifter cable in the shifter cable mounting bracket on the transaxle and use two 11/16”
wrenches to tighten the mounting nuts. Then connect the shifter cable rod end to the shifter arm (Fig-
ure 10-98, Page 70).
21. Attach the ground cable to the mounting screw on the oil filler tube mounting bracket on the engine cyl-
inder head (Figure 10-99, Page 70). Tighten with a 10 mm wrench.
22. Connect the accelerator cable to the actuator cam in the electrical box. Then position the accelerator
cable in the mounting slot in the wall of the electrical box and tighten the mounting nuts using a 10 mm
wrench (Figure 10-100, Page 70). Install the electrical box cover and tighten the mounting screw.
23. Pull the fuel line from the outlet nipple of the fuel pump and connect it to the carburetor, then use a 1/4”
nut driver to secure the hose clamp (Figure 10-101, Page 70).
24. Connect the impulse line to the fuel pump and secure it with the hose clamp (Figure 10-102, Page 70).
25. Connect the air intake hose to the carburetor and secure the hose clamp (Figure 10-103).
26. Connect the overflow tube to the carburetor and secure it with the hose clamp (Figure 10-104).
FIGURE 10-94 FIGURE 10-95
FIGURE 10-96 FIGURE 10-97
CONNECT SHOCK
ABSORBERS TO
LOWER MOUNTS
CONNECT
IGNITION
KILL WIRE
WHITE/BLACK
WIRE
BLACK
WIRE
CONNECT OIL SENDING
UNIT WIRE
F2
DF
F2
CONNECT GROUND
WIRE AT A2 TERMINAL
CONNECT
WHITE
WIRE
CONNECT YELLOW WIRE