Cloos QINEO, Руководство по эксплуатации, Страница: 57 / 186

57
7.1 Parameters in the operating modes 2-cycle and 4-cycle
Function Correction value
Gas pre-flow Off, +/- 99
Inching-in +/- 99
Start program (time) Off, +/- 99
Start program (power) +/- 99
Upslope Off, +/- 99
Main power Absolute value (m/min)
DuoPulse modulation* (+/- 99)
DuoPulse frequency* (+/- 99)
Downslope Off, +/- 99
End crater prog. (Time) Off, +/- 99
End crater prog. (Power) +/- 99
Wire burnback +/- 99
Gas post-flow Off, +/- 99
* Display only if the function is selected!
As far as start, main and end crater power are concerned, the ArcLength
and ArcDynamics can be entered in addition.
7.2 Parameters in the operating mode Super-4-cycle
Function Correction value
Gas pre-flow Off, +/- 99
Inching-in +/- 99
Start program (time) Off, +/- 99, tor
Start program (power) +/- 99
Upslope Off, +/- 99
Main power Absolute value (m/min)
DuoPulse modulation* +/- 99
DuoPulse frequency* +/- 99
Step modulation +/- 9.9
Number of steps. Step (0 - 10)
Downslope Off, +/- 99
End crater prog. (Time) Off, +/- 99
End crater prog. (Power) +/- 99
Wire burnback +/- 99
Gas post-flow Off, +/- 99
As far as start, main and end crater power are concerned, the ArcLength
and ArcDynamics can be entered in addition.
Change of start time:
Turn rotary knob 3
• No time, after "-99" --> "OFF"
• Torch, after "+99"--> "tor"
The start time is determined by means of the torch trigger if "tor" is dis-
played.