5
Installation
The CCRM 4000 is supplied partially disassembled and simply requires reassembly /
push to fit. Below is picture of the fully assembled unit.
To prevent unnecessary damage to the system it
’s vitally important to follow
the instructions below:
1. Remove the CCRM 4000 system from its transportation box and remove the 2
foam end caps.
2. Cut the tape securing the large cardboard box to the large black ceiling frame.
3. Carefully move the box out of the ceiling frame and set to one side being
careful not to snag or cause the microphone cable to kink.
Do not remove
the microphone and pulley assembly at this stage.
4. Remove the small cardboard box located under the CCRM 4000. This
contains the PSU (master only).
5. Now open the large cardboard box and remove from the packaging the large
lower bezel with bezel clamp.
Wall mount
IR sensor
Remote
Top bezel with
pulley
Microphone
