16
Programming cable height on master unit
The remote control is used to set up the cable height and also to deploy and retract
the microphone. For a single unit installation (Master) this has already been factory
defaulted to Master (Master unit decimal code setting is 00)
Point the remote at the IR receiver and press 00 followed by the ENTER
button (Green led will light on the IR sensor showing
it’s in programme mode).
Press the Up / Down buttons on the remote set the correct height of the
microphone, press the ENTER button to store this height position into
the memory (green light will go out). Immediately afterwards the microphone
will retract to the ceiling bezel to confirm that the operation has been
successful.
Test by briefly pressing the Down button on the remote and the microphone
will move down and stop at the programmed height. Press the Up button and
the microphone will retract back up to the Bezel. If an incorrect height has
been programmed then repeat the above instructions.
Programming cable height on a second unit (slave designation 01)
Make sure 01 has been selected on the slave “unit.
