CLIVET WSAN-YMi 101, Инструкция по установке, использованию и обслуживанию

Страница: 89 / 128

Use LEFT RIGHT, UP and DOWN to scroll.
Use UP and DOWN to adjust the time and temperature.
When the cursor is as shown in the figure, press OK.
Timer 1 is selected.
Press OK again, timer 1 is deselected.
Use LEFT RIGHT, UP and DOWN to scroll.
Use UP and DOWN to adjust the time and temperature.
Six periods and six temperatures can be set.
For example: Now time is 8.00 and temperature is 30°C.
Let's set the DEFAULT TEMP.as in the table below.
The following page is displayed:
INFORMATION
When the ambient operation mode is changed, DEFAULT
TEMP. switches off automatically.
It is possible to use the DEFAULT TEMP function in HEAT or
COOL mode. However, if the operating mode is changed, the
DEFAULT TEMP function must be reset again .
The current temperature is not valid when the unit is turned
OFF. It activates at the next default temperature when the unit
turns on again.
The SET CLIM. TEMP. function Allows you to preset the
desired water flow temperature based on the outdoor air
temperature.
When the weather is warmer, the heating decreases.
To save energy, the desired water flow temperature is
decreased when the outdoor temperature increases and the
HEAT mode is active.
MENU> DEFAULT TEMPERATURES> SET CLIM. TEMP. >
Press OK.
The following page is displayed:
INFORMATION
SET. TEMP CLIM. has four types of curves:
1.
high temperature curve for heating
2. low temperature curve for heating
3. high temperature curve for cooling
4. low temperature curve for cooling
If the high temperature for heating is set:
it only has the high temperature setting curve for heating.
If the low temperature for heating is set:
it only has the low temperature setting curve for heating.
And so on.
See the FOR SERVICEMAN > COOL MODE / HEAT MODE
SETTING
The desired temperature T1S cannot be adjusted when the
temperature curve is set to ON.