CLIVET WSAN-YMi 101, Инструкция по установке, использованию и обслуживанию

Страница: 92 / 128

INFORMATION
If CURRENT STATUS is deactivated (OFF), the FAST DHW
function is not valid, while if it is active (ON) the FAST DHW
function is active.
The FAST DHW function is activated once.
This function allows you to force heating of the water in the
tank.
In the same situation, cooling or heating is required and the
heat pump system is operating to produce cooling or heating.
However, hot water is also required.
Furthermore, if the heat pump system is not sufficient, TANK
HEATING can be used to heat the water in the tank.
Select MENU> DOMESTIC HOT WATER> TANK HEATER,
press OK.
Use ON-OFF to select active (ON) or deactivated (OFF),
BACK to exit.
If TANK HEATER is active, the following page is displayed:
INFORMATION
If CURRENT STATUS is deactivated (OFF), TANK HEATER
cannot be activated.
If the T5 tank sensor is in failure, the tank heater cannot work.
The function allows you to return the water to the water
supply. Select MENU> DOMESTIC HOT WATER> DHW
PUMP, press OK.
Move and press OK to select / deselect.
Use LEFT RIGHT and UP and DOWN to scroll and use UP
and DOWN to adjust the parameters.
Example: the parameter relating to the DHW PUMP has been
set (see FOR THE AFTER-SALES SERVICE> DHW MODE
SETTING).
PUMP ACTIVATION TIME is 30 minutes.