CLIVET WSAN-YMi 101, Инструкция по установке, использованию и обслуживанию

Страница: 50 / 128

How to set the AUTO mode
To determine whether the AUTO mode is effective, go to
MENU > FOR SERVICEMAN > AUTO MODE SETTING.
Press OK.
The following page is displayed.
The TEMP. TYPE SETTING is used for selecting whether the
water flow temperature or room temperature(detected by the
temperature sensor attached in the user interface) is used to
control the ON/OFF of the heat pump.
When ROOM TEMP. is enabled, the target outlet water
temperature will be calculated from climate-related curves
(see chapter Start-up and configuration -Climate related
curves ”).
How to enter the temperature
To enter the TEMP.TYPE SETTING, go to MENU > FOR
SERVICEMAN > TEMP. TYPE SETTING.
Press OK.
The following page is displayed:
Only WATER FLOW TEMP = YES
Only ROOM TEMP = YES
WATER FLOW TEMP = YES
+
ROOM TEMP = YES
Zone 1 Zone 2
In this case the setpoint for zone 1 is T1S, the setpoint for
zone 2 is TS (TIS2 is calculated in accordance with the
climatic curve).
DOUBLE ZONE = YES
+
ROOM TEMP = NO
Zona 1 Zona 2
DOUBLE ZONE = YES
+
ROOM TEMP = YES
Zone 1 Zone 2
In this case the setpoint for zone 1 is T1S, the setpoint for
zone 2 is TS (TIS2 is calculated in accordance with the
climatic curve).