CLIVET CSRN-XHE2 Series, Руководство пользователя

Страница: 65 / 92

65
F7 filters (ISO 16890 ePM1 55%)
Option
The pocket filters are not renewable, once dirty they must be
replaced
1 aprire il open the access panel
2 delicately remove the filter avoiding dirtying the area below
3 insert the new filters, with the pockets vertically
4 close the panel
5 dispose of the old filters sending them to specialised recycling
or collection centres (keep to the standards in force)
Electronic filters (ISO 16890 ePM1 90%)
Option
The electronic adjustment is integrated in the filter; maintenance
can be carried out without removing it.
Materials necessary for maintenance
1 Acid detergent B01212 (code CLIVET C6460316);
2 Plastic or steel tank (750x750x310 mm) with settling bottom
3 Protective gloves and goggles;
4 Graduated jug;
5 Pump for manual or pneumatic spraying.
Do not use aluminum tanks or galvanized.
Foresee a stainless steel frame that keeps the filters lifted from
the tank base to have a settling bottom for the muds.
Remove the pre-filter by lifting it of about 1 cm and remove it as
shown in figure.
1 Position the filter to be washed on a support to facilitate
work.
2 Prepare a tank with a solution of B01212 detergent and water
at 1÷20.
3 Immerse the filter in this solution
4 Ensure the solution covers the entire filter
5 Immerse it for about 5-7 minutes. A slight chemical reaction is
noticed within 2÷3 minutes with the development of foam
indicating the occurred elimination of residues.
6 Rinse the filter with a jet of water or using a low-pressure
water jet machine.
7 Leave the electrostatic cells to dry in a hot room or directly
in the sun for a few hours.
Keep the cells lifted from the ground using two metal or
wooden laths.
8 Check the ionisation wires before remounting the filter.
The cleaner can be used to clean about 20 filters.
Can be recovered and placed in plastic containers closed; the air
oxidizes the cleaner and reduces its effectiveness
750
750
310