Climax LM5200, Руководство по эксплуатации

Страница: 43 / 102

P/N 66188, Rev. 5 Page 41
Shims can also be used under the bed to assist in leveling. If the setup area is not level, you
may need to prepare special mounts that fit your application. There are numerous ways to set
up the bed next to the work piece. Rigidity is the most important factor to take into
consideration. When securing and leveling the bed to the work piece, use a precision leveling
tool on the datum surfaces to verify the bed remains level. Refer to the Standard Bed Assembly
section for the procedure on assembling the bed.
Attaching the Saddle
1. Attach the saddle plate to the rail blocks as shown in Figure 9. The outside edge should
be flush with the rail blocks. This aligns the saddle to the bed and in turn aligns the ram
to the bed.
2. Check for free movement of the saddle up and down the entire length of the bed. If the
saddle shows resistance at any point, stop and check the bed and rails to be sure they
are level and straight.
Figure 9
3. Attach the saddle to the ballscrew mounts.
Repeat the previous steps to attach the other half of the saddle to the other side of the bed
assembly. Align the second half of the saddle with the first one prior to fastening it down.
INFORMATION
The saddle can be moved up and down the rail quickly by using a standard
electric hand drill with a socket attachment when the ballscrew is installed.
Attaching the Ram
To attach the ram, use the lifting eyes provided on the ram to position it in place.
1. Press the front edge of the ram against the inside of the ram clamp. This aligns the ram
perpendicular to the bed. Then attach the ram as shown in Figure 10.