Climax LM5200, Руководство по эксплуатации

Страница: 52 / 102

Page 50 LM5200 Operating Manual
Attaching the Feed Motors
Motor attached to ballscrew on bed
Motor attached to ballscrew on ram
The feed motors are attached by aligning the hex and sliding the feed motor in place then
tightening the clamp collar to secure it. Attach the feed motor(s) to the desired ballscrew and
connect the control cables. The feed is controlled using the pendant attached to the HPU or
stand-alone feed control.
Gantry Linear Mill Setup
The following is a suggested method of mounting and aligning the gantry style bed. What
method is used varies greatly depending on the work piece and the equipment available to
assist with setup. The setup described assumes a horizontal work piece. This setup would also
work for a vertical work piece with the machine mounted horizontal, and the milling assembly
turned 90°. Setting up the machine on a vertical work piece with the bed mounted vertically can
be done but it requires more extensive equipment such as a laser plane to ensure the bed
sections are co-planar. Refer to the Gantry Bed Assembly section for the procedure on
assembling the bed. This procedure assumes the ballscrew and saddle plates are installed.
Coplanar Setup
1. Position the drive side of the bed. Ensure that when the drive side is leveled, the gantry
side is capable of being made coplanar with it.
2. Level the drive side of the bed using a precision leveling tool, and tighten it down.
3. Position the gantry side of the bed, and rough align it using a tape measure.
4. Place the ram on the saddle plates, and tighten the ram clamps on the drive side as
shown in Figure 13. Leave the ram clamps loose on the gantry side.